Washing equipment at first glance is very clean, but there are still a laundry outside the cylinder sleeve, laundry water flows back and forth among the two mezzanine, over time, will be attached to a lot of dirt in the sandwich.The dirt in the laundry serious secondary pollution not only clothing, also harm to human health.Therefore, we need to often clean the washing equipment and disinfection.Generally speaking, the new washing machines use after six months, every two or three months should clean disinfection.
Non-metal tank washing equipment in the chlorine-antiseptic 300 PPM to 500 PPM (parts per million (PPM) is one over one million) aqueous solution, open the back three minutes to 5 minutes.Metal tank washing equipment into the content of 0.5% - 0.5% glutaraldehyde solution soak for 10 minutes to 15 minutes back.Because the mold is very sensitive to temperature, survival rate is very low, in 35 ℃ water in 45 ℃ hot water is almost zero, so use 45 ℃ hot water cleaning can effectively kill the mold.
Washing equipment cleaning and matters needing attention
1, store in ventilated dry place, avoid in a bathroom.
2, the drain must be higher than the drainage pipe, water can not be left in the drainage tube.
3, when not to pick the filter bag hanging outside and let it fully dry.
4 immediately take out air, washing the clothes, do not stuffy inside.
5, washes the clothes must put out all the water in the washing machines and open air, in order to avoid the remaining water inside the machine form microbial breeding grounds.
6, drainage pipeline had better use clean water to wash after each use.
7, after the top open the door of the washing equipment used to use dry cloth to dry, its internal water side door of the washing equipment in addition to dry the water from the washer mounted on the door, lest cause mould.
Washing coup within the barrel is the correct way of cleaning the washing equipment
- The last article：Large installation and laundry...
- The next article：Hotel dehydrator belt tightnes...
