Hotel large washing equipment operation process

(1)using washing equipment, every day to the door, drum washing machine, washing supplies charging device, drive belt for visual check.
(2) each time should check before starting the program: select washing degree card card control type washing machine, microcomputer control type washing machine selection process.
(3) its test washing machine washing equipment functions, including: positive &negative, high-speed dehydration function, high and low water level and temperature in modern device, etc.The cold water, hot water for 1 minute each, retention of water in water tube.Exhaust steam for 15 seconds, in order to rule out the possibility of management within the fouling.
(4) when the temperature display is 160 ℃, the press of a pneumatic control switch down drum, the drum and heating chassis.
(5) press the start switch, roller rotation, and adjust the speed.
(6) check the machine before and after the emergency switch is sensitive and into cloth armor.
(7) adjust the roller speed to the slowest speed, by taken special clean cloth belt machine, clean heating chassis for several times, again lead several wet cloth, and then through the cloth and put a candle wax powder lubrication chassis and drum.
(8) the roller speed setting to stay hot fabric the required speed.
The fabric flat (9) the operator on the belt, let drive roller into the heat press within the chassis.
(10) are check running status of the wrinkles in the fabric, if the bed sheet fabric such as walking skew can adjust the left and right sides of the cylinder pressure, cylinder pressure around general adjustment for the 0-0.4 Mpa, if the fabric drape should adjust the roller speed, generally before the roller speed ratio of 0.95 to 0.95, after the roller speed ratio of 1.00 to 1.00.
(11) when fabric is roller rolling press, after coming out of heating chassis is cloth plate, the operator to take out the manual folding (or automatic folding machine folding)
(12) each hot wax powder after a certain number (typically 200) after the tablecloth, evenly sprinkle on wax cloth to clean the wax powder, wax with a clean cloth in very hot bed 2-3 times, wax powder should not be too much.Daily work, using special cleaning cloth to clean the heating chassis may fouling.
(13) washing equipment washing machine washing equipment is the best loading capacity of 80% of design capacity, the overload operation is not allowed.
(14) during washing equipment operation, attention should be paid to observe its working condition, if any accident should be immediately cut off power supply, water supply, gas source.
(15) daily use after the machine, the machine power switch should be closed.Visual or touch to check whether there is abnormal motor and drive system, close the steam valve, hot and cold water switch and total power switch.

The last article：Buy what you need to start the...
The next article：Hotel of washing equipment was...