Hotel laundry inside large washing equipment can not do without water, water is the core of the washing equipment operation, a but washing equipment in and out of the water system fails the whole washing equipment will be in a stop state.So today ENEJEAN washing equipment experts say to everyone about washing equipment in and out of the water system for the maintenance of a series of fault:
Washing machines into the water slowly, how repair?
The water slowly, should first check whether the tap water pressure is too low;Under normal circumstances, the inlet valve has a problem, is generally filter clogging or current-limiting pad installed improperly.Maintenance, can be taken from the inlet valve inlet filter, clip out of the current limiting rubber mat, after cleaning, put on again.
After washing machines can fill, but into the water should not be washed, how repair?
After into the water can not enter a state of washing, is due to water level switch in the intermediate state.The water level switch is normally closed contact of the disconnect, and normally open is not closed, program-controlled machine no electricity, also cannot enter into the state of washing.Maintenance, as long as the reset screw adjusting switch to distinguish is high water or low water levels.High water reduction and adjust to the external, low water level low water reduction and screw should be adjusted.
Washing machines do not water, how repair?
1. Water electromagnetic valve power supply not normal;2. Water intake solenoid valve control circuit breaker;3. Water electromagnetic valve damage;4. Water level controller has a fault;5. The program controller do not work properly;
Washing equipment in normal washing does not regulate forced water program, and continue into the water, how to repair?
This phenomenon is caused by chronic gas leak water level switch, tighten iron ring seal is lax, available combination pliers will be retightened iron ring, and make the seal;Microporous flat rubber membrane, rubber membrane leakage repair inconvenience.Only the change of water level switch.
After the water washing equipment, after reaching level is still more than the water, how to repair?
More than the water inlet valve defective.Inlet valve spring force is too weak;Maintenance when open inlet valve, the valve core at the top of the spring stretched, appropriate to enhance elasticity.Water inlet valve of the bottom of heart uneven rubber cap;Open inlet valve and maintenance on the rubber cap clean of impurities, and the repair level off, and new clothes.
If you do not have the professional knowledge of maintenance, please do not separate apart without authorization machine maintenance!Safety first!
About the hotel large washing equipment in and out of the water system fault maintenance
- The last article：Came to a sudden stop in the p...
- The next article：Hotel washing equipment due to...
